How Do I Make A Roof Rake

Use the drill to make a hole in the aluminum pole using the bracket holes as a guide.

How do i make a roof rake.

Make this easy avalanche roof rake for the winter and let a clever diy design do all the work for you. How to make a roof rake step 1. Rake plates of one by 2 inches often cover the exposed top edge of the liner when there is also a ledge at the end of the gable. I used the driveway sealer squeegee and an extension pole to work as a snow roof rake.

An added bonus was that i could use one end of. Begin by cutting two 12 sections from one on the 1 x 10 pvc pipes. Without a real roof rake i was forced into searching the garage to craft something homemade. On the 1 x 12 arms where you placed the marks in the previous step use the hole saw to bore straight through.

When the snow started to pile up on handyman bill. Use larger rake plates such as 1 by 4 inches and 1 by 6 inches when there is an infinity ledge at the end of the gable. Drill straight through the aluminum handle through one bracket hole to the hole on the other side using your. Use your clamp to attach the two 4 inch brackets to one end of the aluminum pole positioning one angled bracket on each side.

Attach the two 4 inch angle brackets to the end of your aluminum pole. Here s what i came up with. The roof rake plates are installed in different widths depending on the surface being covered. I have to say it worked great i used the metal part face down not the rubber part.

Measure and place a mark 2 from an end. Position a bracket on each side of the.