Push the pole into a vertical position.
How do you penetrate the roof for an antenna.
Use a trowel to spread the cement.
Put a layer 1 8 14 thick of roof cement over the holes directly on the shingles and overlap that area approximately 1 2 1 larger than the bracket.
If you decide to remove your antenna from the roof make sure you don t leave a hole in the roof or you ll be headed for other problems.
If you cannot cover the hole appropriately leave the base of the antenna attached to the roof so no hole is created.
Otherwise if you don t like that metal thing on top of your roof there are many.
Remove the pole base bolt and nut insert it through the hole in the base of the pole and finger tighten the nut.
Once the fundamental of available signal strength is understood we consider the variables that will effect that signal roof surface generally a tile roof will pass the signal without too much degradation.
You can also buy non penetrating mounts that use weights rather than screws to hold them in place.
In order to mount an antenna on your roof without damaging it you should attach the antenna to the gable the fascia or the chimney.
You may want to check this with a spirit level.
You may need to loosen the bolt and nut on the collar first.
Insert the pole though the tripod collar hole end down.
It ll help to have someone assist you on the ground to report the quality of reception with each change you make to the antenna.