How For Put Nail On The Felt In Roll Roofing

If you have a sloped roof cut strips of roofing 9 inches wide position them flush with the drip edges along the eave and rake and attach them by driving two rows of nails that are about 3 inches apart.

How for put nail on the felt in roll roofing.

The entire length of the valley should be covered with a sheet of roll roofing that is at least 18 inches wide. Apply rolled roofing rolled roofing has become more and more popular in recent years. Nail the two rolls in the overlap at 12 inch intervals. Roll the roof paper up and over the peak.

Step 6 overlap next roll. Nail the roofing in place with short roofing nails spaced 6 inches apart and 1 inch in from the outer edges of the roll roofing. Use 1 inch nails for new roofing. Step 5 secure ends.

Secure the outside edges with plastic capped roofing nails at 12 inch intervals. The nails should start 3 4 inch from the edges of the roofing and be 6 inches apart throughout the roofing s surface. Where a roll ends and a new one is begun the two rolls should be overlapped by four inches. Start the roof felt at one bottom corner of the roof.

They are long enough to penetrate the sheathing. When compared to shingles rolled roofing is far cheaper and much easie. Step 3 nail down the 18 inch roll roofing sheet that it is covering the valley. The paper should then be nailed in or stapled every three to four inches across.

You will need 1 10 gallon of lap not mastic cement for every roll and 2 pounds of roofing nails for every square. Tack it in place at the corner with the end flush with the end of the roof and the bottom edge of the roll right along the bottom of the roof. In roofing one square equals 100 square feet. Place this roofing material so it straddles the valley.

An underlayment of felt roofing is optional. Repeat this until the entire roof is. All nails and staples should be placed on the lower half of the paper.